Home. About Us. Professional Packaging. Orders Tracking. New Products. News. All Products. Feedbacks / Reviews. Special Offer. Warranty / Return. Contact.
© 2002 - 2015 Cattylink Analog Research Limited

RomanCart: View Cart RomanCart: View Cart
about us     warranty / return    packaging     new products    all products     orders tracking     reviews     special offer     contact
about us     warranty / return    packaging     new products    all products     orders tracking     reviews     special offer     contact





   This integrated valve amplifier looks as good as it sounds. The owner may adjust the bias of the power valves by using gain controls and a high precision VU meter on the outside of the amplifier. To control the input voltage of the power stage, it uses 6CG7 valves, which improve the stability of the four KT88 for each channel. This makes the frequency range of the power stage more linear. That may sound very complex to anyone not involved in the secrets of valve design, but you don’t need to be a technical expert to feel the beauty of sound reproduction, which is possible by connecting it to your speakers.


Can be used as integrated amplifier or power amplifier

2 x 6CG7 + 2 x 12AU7 + 1 x 12AX7 for pre-amplifier stage

High power fully matched KT88 x 8 for strong power output

High end Nichicon capacitors, Realcap capacitors and audio choke

Silver plated high purity copper internal signal wiring

High quality Japan ALPS motorized volume control

Special handmade low magnetic leakage toroidal power transformer

Special handmade wide frequency response Ei audio transformers

Ultralinear / Triode mode selection (selectable via remote control unit)

All point to point wiring (hand soldering)

Fully remote controllable

4 pairs RCA input + 1 pair RCA pre-amplifier input

1 pair RCA tape output

4ohm / 8ohm selectable output load impedance

Removable metallic tube protection cage included

Full remote control

Detachable power cord system (IEC)


Power output RMS: 2 x 70W ultralinear mode, 2 x 40W triode mode

Frequency Response: 12Hz - 40kHz, +/-1.5db

Input sensitivity: 420mV (integrated)

                               650mV (pre-amplifier input)

Input impedance: 100Kohms

Output load impedance: 4ohms, 8ohms selectable

THD+N: ≤ 0.5%, 1W,1Khz

S/N ratio: ≥ 89db

Power Consumption: 480W

Dimension W x H x D : 440 x 222 x 390 mm

Voltage Standard Available: 220V, 230V, 240V

Further Questions: info@cattylink.com

After sales and Warranty: service@cattylink.com